Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Charging your climbing car by USB cable
1. Make sure the car is switched"OFF" before charging. When the front/rear lights starts
flashing, it means the battery is low and needs to be recharged.
2. Connect the car with the USB cable and insert the USB plug into USB socket.
The charging indicating light on the USB will be"ON"while charging and will go"OFF"
once the charging is complete.
Playing Environment
1. Stand at least 4 meters from the wall.
2. Please only play the car on clear, empty wall with smooth solid surface.
3. Do not drive over wall sockets, switches or other obstructions.
4. Do not drive to or off the edge of the wall.
5. Do not drive on the ceiling while people is around.
6. Do not stand underneath when driving on the ceiling.
How to select the BAND
This product usues"auto-match"frequency technology. Please follow the steps
below to operate:
1. Select the frequency of choice (A, B or C) using the selector switch
on the controller and then switch on the controller.
2. Switch on the car
3. Now the car is ready to run.
Attention: To play more than one car in the same area at the same tome you must repeat the above procedure, but select
a different frequency (A, B, or C) to the other car using the switch on the controller.
Drive on the wall
IMPORTANT:
Before turning controller ON, make
sure that both joysticks are in the
neutral (middle) position.
OFF
Neutral
positions
1. Turn the controller"ON".
NO!
ON
2. Select the WALL mode.
Werbung
