i-tec C31METALGLAN Gebrauchsanweisung Seite 7

INTRODUCTION
i-tec USB-C Gigabit Ethernet Adapter allows user's computer instantly
connect to a 10 / 100 / 1000Mbps network through an USB-C port.
SPECIFICATION
• USB-C to 10 / 100 / 1000Mbps Gigabit Ethernet
• 1x RJ-45 for Ethernet cable connection
• Supports Wake-on-LAN, Jumbo frame up to 9k bytes, detection of
cable crossover MDI / MDIX
• Support IEEE 802.3az (Energy Efficient Ethernet)
• Support IPv4/IPv6 pack Checksum Offload Engine (COE) to reduce
CPU loading
• Chipset Realtek RTL8153
• Power: USB Bus Power 5V
• Supported OS: Windows 7, Windows 8, Windows 8.1,
Windows 10, macOS X, Linux, Android
• Operation Temperature: 10-40°C
• Storage Temperature: -10-80°C
• Dimensions: 61 x 23 x 17 mm
• Weight: 35 g
SYSTEM REQUIREMENTS
Windows 7 / 8 / 8.1 / 10; macOS X; Linux; Android
Free USB-C port
DRIVER INSTALLATION
Windows Operating System
It is not necessary to install device drivers. The drivers are automatically
installed from the system or Windows Update after the connection. In
case of problems with the installation you can download the drivers on
www.i-tec.cz/en.
macOS
It is not necessary to install device drivers. The drivers are automatically
installed from macOS X after the connection. In case of problems with
the installation you can download the drivers on www.i-tec.cz/en.
CONNECTION TO A NOTEBOOK / PC
Connect the adapter to an available network when the installation
procedure is completed.
• Connect an Ethernet cable to the Ethernet port of the adapter, and
then connect the other end of the Ethernet cable to an available
network HUB, switch or router.
Quick Start
| 7
ENGLISH