Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION INSTRUCTIONS
The installation must be performed by a qualified electrical contractor.
How to stick the gasket:
The gasket supplied with the hob prevents the intrusion of liquids into the cabinet below.
It's installation has to be done carefully, in conformity with the following drawing.
itting - installing:
F
• The cut out sizes are:
Cut size
Width
Depth
750
490
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or divider must stand higher than
the hob.
• The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• Do not install the hob at the top of a non ventilated oven or a dishwasher.
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection tape (3).
Flush mounting
Width
Depth
Radius
906
526
87
Glass size
Width
Depth
8
900
Filters installation
Thickness
520
4
Werbung
