Arzum OKKA GRANDIO DUO Gebrauchsanweisung Seite 28

All manuals and user guides at all-guides.com
g. When the coffee pots are placed into their slots in 30 seconds, the
machine receives water and the measurement mode starts.
*The process continues until the coffee pots are in their place during the
calibration. The calibration is automatically canceled when the appliance
is switched off and on again.
h. During the process, the appliance will perform the boiling process with
at least 4 cups of water. After the boiling process, the measurement
process ends with sound and light warning.
WARNING: The water tank of the appliance should contain maximum
level of water during this process.
WARNING: Coffee pots are placed in their slot emptily without coffee and
sugar.
WARNING: In case of a problem during automatic boiling point
measurement, restart your appliance and restart the process.
WARNING: If the coffee pots or one of the coffee pots are/is removed
or the appliance is closed before the measurement mode ends, start
the process from the beginning.
WARNING During the measurement of boiling point, water doplets
may form on the touch panel and surfaces due to water boiling in the
pot(s). After boiling process finished, wipe and dry out droplets with a
dry fabric.
In the cases where manual boiling point measurement should
performed;
• In case the coffee pot and/or board are changed for any reason by the
service after the automatic measurement,
• Change of the altitude where the product is used (city, change address,
etc...)
• In case of a problem in the automatic measurement.
AMBIANTE LIGHTING
OKKA Grandio Duo has a stylish image with ambience lighting on
the coffee pot. Provides ease of use where the ambient light is not
sufficient.
4. NOtICe AND WArNINGS
28 ARZUM OKKA GRANDIO DUO
Brewing not
allowed
The water tank is empty or not in the place
- Make sure there is enough water in the water tank.
- Make sure the water tank is tightly fit in its place.
- A warning light comes on when the water level is dropped below 450
ml in the water tank. If the warning light comes on during brewing, the
existing brewing process will continue, but a new brewing cannot be
started. In order to do this, water should be loaded to the tank until the
maximum level.
Coffee pot is not in the place
The product is
1
ready to brewing