ROWENTA PowerLine DM-100 Gebrauchsanweisung Seite 7

ENGLISH
For appliance description see diagram on page 3:
A Spray jet
B Water filling inlet
C Steam control slide with self-clean
function
D Spray control
E Steam jet control
F Flexible cord support or protector
SAFETY INSTRUCTIONS:
Read these operating instructions thoroughly and keep them in an
accessible place.
The appliance complies with EU directives 72/23/EEC and 89/336/EEC.
The appliance may only be connected to alternating current as specified
on the rating plate.
U.K. ONLY
SAFETY POINTS FOR REWIREABLE OR MOULDED PLUG:
The mains lead is fitted with a BS 1363 13A plug.
If the plug supplied with the product is not suitable for your socket
outlet, then it must be removed (cut off, if it is a moulded-on plug) and a
suitable 3 pin plug fitted in accordance with the instructions given below.
IF YOU ARE IN ANY DOUBT, PLEASE CONTACT A QUALIFIED
ELECTRICIAN.
WARNING: Dispose of a plug that has been cut from the power supply
cord, as such a plug is hazardous if inserted in a live 13 A socket outlet
elsewhere in the house.
How to connect the cord to a U.K.plug:
IMPORTANT!
The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow
Blue
Brown
Please read the instructions given below
before connecting the cord to a plug. If
you are in any doubt please consult a
qualified electrician.
WARNING! THIS APPLIANCE MUST BE
EARTHED!
As the colours of the wires in the mains lead of this iron may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire that is coloured GREEN & YELLOW must be connected to the
terminal in the plug which is marked with the letter E, or the earth
Symbol
The wire that is coloured BROWN must be connected to the terminal
which is marked with the letter L or coloured RED.
The wire that is coloured BLUE must be connected to the terminal which
is marked with the letter N or coloured BLACK.
This appliance requires a 13 amp fuse.
Should the fuse need to be replaced an ASTA marked fuse, approved to
BS 1362, of the same rating must be used.
Always replace the fuse cover after fitting a fuse. The plug must NOT be
used if the cover is omitted or lost until a replacement is obtained - make
certain that only the correct fuse cover is used and fitted.
For plugs with a detachable fuse cover, the replacement must be the
same as the colour insert in the base of the plug, or as directed by the
embossed working on the base of the plug.
If the detachable fuse cover is lost, a replacement may be purchased from
a Rowenta Service Centre (see enclosed Service Information leaflet).
Information for supply may also be obtained from the plug manufacturer.
DM-100
Earth
Neutral
Live
, or coloured GREEN or GREEN & YELLOW.
G Mains supply cord
H Warning light
I Infinitely variable temperature
control
J Soleplate (Depending on Model)
K Transparent water tank
L Maximum water level indicator
7