B.A. International Ulticlean UC400 Gebrauchsanweisung Seite 14

If your ultrasonic cleaner does not operate to your satisfaction, please consult
the guide below before calling your authorized service center/centre.
Cleaner will not start
Cleaner operates but
does not heat solution
Cleaner will not drain
Decreased
ultrasonic activity
Trouble Shooting
•
Cleaner not plugged
in properly;
•
Timer not ON;
•
Timer Light Not on;
•
Blown fuse
•
Heat switch not ON; Turn heat ON
•
Heater malfunctions Call authorized service
•
Clogged drain
•
Solution is not
degassed
•
Solution is spent
•
Solution level is
incorrect for the
load
•
Tank bottom is
covered with soil
particles
•
Using de-ionized
water in the tank
14
Plug into a functioning
electrical outlet/socket;
Turn timer clockwise
Turn rear power
switch ON
Call authorized service
Center/centre
Center/centre
Call nearest service
Center/centre
Make sure the tank was
filled with warm tap water
plus cleaning solution and
has run 5 to 10 minutes
Change solution
Adjust solution level to
one inch from the top of
the tank with the load
Empty, clean the tank
with warm water and a
non-abrasive cloth
Do not use. De-ionized
water does not cavitate
as well a ultrasonic
solutions.