Adeunis RF ARF33-PRO Bedienungsanleitung Seite 44

R/W S219
Protocol
R/W S220
R/W S252
R/W S256
Protocol
R/W S205
R/W S207
Function
repeater
R/W S244
R/W S250
R/W S300
NOTE 1
When a change of serial speed is requested, the values of the S214 and S217 registers are automatically set to
a value greater than or equal to the period of three characters at the speed requested (13 ms for 2400 bauds, 7
ms for 4800, otherwise 3 ms)
NOTE 2
Transmission mode without flow control. Please note that using a serial transmission rate that is higher than the
radio transmission rate will of necessity lead to the loss of characters in the absence of flow control.
If the radio transmission rate is equal to the serial transmission rate, the radio frame is longer than the serial
frame due to the header required by the radio protocol; but the radio header will only be generated at the start of
the radio transmission and this header will be absorbed by the size of the internal buffer.
For example, if the current radio transmission rate is 10 kbits/s, a serial transmission rate of 9600 must be used
without flow control, while a serial transmission rate of 19,200 (with 10 kbits/s for the radio transmission rate) will
produce a data overflow.
208210A_UG_V1.6_ARFx3-PRO
All manuals and user guides at all-guides.com
RS485 delay Delay between DE activation and
the first RS485 byte transmitted
from 0 to 160
Protocol «1» = transparent mode
«6»= addressed
Reception address from 0 to FFFF
Used in addressed protocol only, in
order to filter the incoming frame.
0xFFFF reserved for transmission
(additional information in "repeater
application note")
Transmission from 0 to FFFF
address Used in addressed protocol only, in
order to filter the outgoing frame.
Pin Code Pin Code value
The value 0000 is not possible
Pin Code activa- 0 Pin code deactivated
tion 1 Pin code activated
Repeater number from 0 to 100
0: repetition is not enabled (default
value)
1-100 -> repeater enabled; this
value is used to define the waiting
period before transmission
(additional information in "repeater
application note»)
Forced repetition 0 -> Conditional repetition
1 -> Unconditional repetition
(additional information in "repeater
application note")
RSSI serialization 0-> no serialized RSSI
2 -> serialized RSSI
3
6
1111
0
0
0
0 6
43