Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Remote Control
The remote control is supplied with a battery inserted. An insulating foil
between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the
battery support on the rear side of the remote control. Otherwise operation of
the remote control is not possible.
If the range of the remote control decreases, replace the
battery. For this purpose, on the rear side of the remote
control press the small bar with the groove to the right
and at the same time remove the battery support. For
operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the
support.
Danger of explosion when battery is replaced improperly. Only
replace by the same type. Please dispose of old and used
batteries properly. Batteries are hazardous waste and should not
be disposed of with regular domestic waste!
...............................................................................................................................................
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
Connections:
Max. input level/impedance:
Max. output level:
Frequency range:
S/N ratio:
THD:
Dimensions:
Weight:
Battery/remote:
CAUTION!
12 V DC, 150 mA via supplied PSU
connected to 230 V~, 50 Hz
2 W
RCA L/R
1.65 V /47 kΩ
2 V
20 Hz - 20 kHz
>90 dB
0.2 %
76 x 93 x 26 mm
370 g
1 x CR 2025
11
Werbung
Inhaltsverzeichnis
