Commodore Amiga 1084S Bedienungsanleitung Seite 7

GB-8 Monitor 1084S
To connect the audio, locate the audio cable with one pair of phono plugs at
each end ofthe cable. One pair of phono plugs is plugged into the AUDIO R and
AUDIO L jacks on the back of your monitor, and the other pair of plugs is in-
serted into the Amiga's left and right audio jacks.
3.1.1 Using Headphones
You can connect headphones to your 1084S so that stereo sounds generated
by your Amiga computer can only be heard through the headset. To do this, sim-
ply insert the plug on the end of a standard headphone cable into the small silver
port on the left side (as you face the front) of the monitor's cabinet. The port is
towards the front of the monitor. A headphone cable is not included with your
monitor but should be readily available at most computer and electronics stores.
3.2 Connecting the Separate Luma-Chroma-Audio Display (C64)
Take the video cable with three phono plugs on one end and an 8-pin connector
on the other end. To connect the video cable, insert the yellow phono plug into
the jack labelled CVBS/L, the red phone plug into the jack labelled CHROMA,
and the white phono plug into the jack labeled AUDIO/L on the back of your
1084S. Then insert the other end of the cable with the 8-pin DIN connector into
the video port on the back of your Commodore 64. Set the CVBS/LCA switch to
LCA mode.
Monitor 1084S GB-9
3.3 Connecting the Composite Display
Some older C64's have a 5-pin DIN video connector which outputs composite
video. To attach your 1084S to this older style C64, a 5-pin DIN video cable is
required (not included, but commonly available at many stores that carry the
C64 line). Set the CVBS/RGB switch on the rear of the monitor to CVBS mode.
Insert the 5-pin DIN connector into the Video port on your Commodore 64, and
insert the phono jack into the port labeled CVBS/L on your 1084S. Set the
CVBS/LCA switch on the rear of the monitor to the CVBS position.
3.4 Connecting the Monitor to the Mains (for U.K, only)
Your 1084S monitor is designed to operate from an a.c. mains supply of 220-
240 volts, 50 Hz. If the mains voltage in your home is different from this, con-
sult your dealer. Stabilising circuits ensure satisfactory performance within nor-
mal supply variations.
Important: This apparatus must be earthed. This can be achieved by fitting a 3-pin
plug. The wires in the earthed mains lead are coloured according to the following code:
BLUE = Neutral
BROWN = Live
GREEN/YELLOW = Earth
If the mains plug (or adaptor) contains a fuse, the value of this fuse should be 3
Amp. Alternatively, if another type of plug (not fused) is used, the fuse at the dis-
tribution board should not be greater than 5 Amp. If the colours of the wires in
the mains lead do not correspond with the coloured markings identifying the ter-
minals in your plug, proceed as follows:
The BLUE wire should be connected to the terminal marked "N" or coloured
black. The BROWN wire should be connected to the terminal marked "L" or
coloured red. The GREEN/YELLOW wire should be connected to the terminal
marked "E" or earth symbol, or coloured green and yellow.