Commodore Amiga 1084S Bedienungsanleitung Seite 4

GB-2 Monitor 1084S
WARNING
Monitor 1084S GB-3
1. Introducing your Monitor
The 1084S works in three different operating modes: Composite (PAL standard),
Separated LCA (Luma-Chroma-Audio), and Analog RGB. It also allows both a
40-column screen display, for use in Composite and Separated modes, and an
80-column display for Analog RGB modes. The mode you choose will depend
on the type of computer you are using.
Before you proceed any further, check to make sure you have received everything:
e One 1084S-monitor
e Cables:
— For connecting an Amiga Computer - one cable with a 23-pin D (rectan-
— For connecting an Amiga's audio capabilities - one cable with two RCA
plugs on each end.
— Power cable for connecting the 1084S to an AC power source.
e Warranty card
Note: The following monitor cable is also available for use with the 1084S. This
cable can be purchased from your Commodore dealer separately.
e For connecting a Commodore 64 - one cable with an 8-pin DIN connector on
the computer end and 3 phono plugs on the monitor end (provides separate
LCA display).