XCLEA QYSDJ01 Bedienungsanleitung Seite 15

Disassembling and installing the mop
Step 1: Disassemble the mop
Remove the mopping module from the dust box + water thank (2 in 1), and remove the mop from
the mopping module.
Caution
1. Only replace with a mop supplied by XCLEA, otherwise, it may lead to ineffective cleaning.
2. Be sure to remove and clean the mop to prevent dirty water flowing back.
3. It is recommended to replace the mop every 3-6 months to ensure effective cleaning.
Cleaning the replacement parts
Step 1: Clean the sensors
Use a soft clean cloth to wipe and clean the charging plates on the back, the laser distance sensor
on the top, the edge sensors, the infrared docking sensors and the TOF wall tracking sensor.
Step 2: Clean the mop
Rinse the mop with clean water. Air-dry completely before reinstalling to prevent dust from
clumping during the next use.
Step 2: Clean the universal wheel
Turn the robot vacuum and mop cleaner over and pull out the universal wheel, clean out the hair
and dirt from the wheel and axle. Wash the universal wheel with water, air-dry completely and
reinstall it.
13