Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Illustration 2 and illustration 5
Programming of radio telecontrols if there is only 1 DH... unit and it is
defective (for drives type GTS30, GTS35, GTD50, GTD55, GTO90,
WTO100, WU100, WU200 and A85R equipped with 13-pole decoder).
Coding set manually on remote control unit type HS/M
1.
Open battery compartment
2.
Press reset key
3.
Immediately set desired coding, note that the upper key is programmed
with the value "1" (coding key ON, jumper not separated) and the lower
key has the value "0" (coding key OFF, jumper separated). The LED
darkens as soon as a key has been actuated.
Example: 1111100000 = 5 x upper key and then 5x lower key.
4.
Programming ends with the 10th key actuation and the LED
flashes quickly for a few seconds.
5.
Close battery compartment.
Test functions!
Should the unit malfunction, repeat steps 1-5.
Illustration 6
Channel loading
After manually setting coding the keys are pre-programmed to the channels
A-H (confer illustration 6). The discrimination of channels A...H is necessary
for use with a multiple party garage, in which each user has their own drive.
Channel A is normally used with single-garage doors.
11.2002 V1.0 / 436 008 RE
O
c
O
O
e , the LED
a illuminates.
O
a
O
a
17
Werbung
