Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Hold the remote control DH...
(transferring unit) and the remote control unit that is to receive the
coding (receiving unit) HS/M
2.
Press desired key from transferring unit
3.
Immediately press the appropriate key of the receiving unit
hold. The receiving unit LED flashes at a slow rate for 4 seconds and
after successful coding transfer the flash intervals increase.
4.
Release keys from both units.
Test function!
Should the remote control unit malfunction, repeat steps 1-4.
The transfer of a coding can be carried out for all double tapper keys
(channels E-H)
Important:
In the event that the you should release the under step 3 actuated key
during the initial 4 seconds, the transfer procedure will be cut off.
Illustration 4
GTS40, GTD60, SupraMatic S/K (confer illustration) and industrial door
control units without coding key, e.g. A100, A/B60, A/B300, A70 R Vario
(not shown).
Programming can only be carried out if there is only 1 DH... unit and it is
defective.
This procedure is necessary if there is no coding key or mechanism on the
door opener drive or the electric controls for coding remote controls.
11.2002 V1.0 / 436 008 RE
O
a that is to transfer the coding
O
b directly next to each other.
O
a and hold.
O
b and
15
Werbung
