Teka 115330047 Montageanleitung Seite 7

Installation
This sink has been subjected to several qua-
lity inspections and has left our plant in per-
fect condition. Should you nevertheless find it
to be faulty, please report the defect prior to
installing the sink in order to avoid unneces-
sary costs. In this
in its original packaging for instection purpo-
ses. Unfortunately,
defects discovered after mounting.
contact your specialist
complaints.
As we cannot accept liability for faulty
ting, we ask you to comply with the following
instructions.
lmportant:
Never set the sink on its edge, as this could
result in chipping!
6
case, the sink must remain
we cannot admit claims her
retailer for
Prior to mounting
1. Hole for tap fittings
The pre-drilled hole (semi-punched hole) has
been cut to fit taps with a shaft diameter of
35 mm.
Please Ensure that the sink is evenly supported wit-
hin approximately 15 mm on either side of the
any
pre-drilled
the hole with a small chisel or
moun-
For taps with a shaft diameter exceeding 35
mm, the hole must be
This can be done with a compass saw fitted
with a blade suitable for sawing metal.
Saw out of the hole in a
toothed pattern as shown
in the illustration and care-
fully break off the projec-
tions thus
pliers. Caution: do not use
force.
2. Fixing clamps
Insert the enclosed
clamps (1) into the
preformed slots (2)
on the undersite of
the sink.
hole. From above,
screwdriver.
widened.
formed with
carefully pierce