Super Handy GBTS010 Bedienungsanleitung Seite 15

1. One LED: 0~40% battery capacity;
2. Two LED: 40%~70% battery capacity;
3. Three LED: 70%~85% battery capacity;
4. Four LED: 85%~100% battery capacity.
Soft Riding Condition. When the battery is nearly depleted, a "soft" riding condition can occur.
A "soft" riding condition means the scooter can move forward at lower speed compared with
fully charged battery. When this happens, turn the scooter back on and drive the scooter under
low speed until you can recharge the battery, or exchange a new battery.
CHARGER
1. The battery is charging when the LED light on the charger is red. When the battery is 100%
charged, the light on the charger will turn solid green.
2. The provided charger has a built-in overcharge protection to prevent the battery from being
overcharged.
3. Charging time is approximately 1.5 hours for a fully discharged battery.
4. Regularly inspect the charger for damage to the cord, plug, enclosure and other parts. In the
event of such damage, the charger must not be used until it has been repaired or replaced.
5. Unplug the charger from the wall outlet when not in use. As a safety mechanism, when the
charger stops charging because the battery is full, the charger must be reset by
unplugging it from the wall outlet before it will resume charging.
6. Use only the charger supplied with this scooter or a recommended replacement
specified by SuperHandy.
Failure to confirm compatibility, properly install, operate and maintain any charger,
component or accessory can result in serious injury or death.
INSTRUCTIONS FOR CHARGING
1. Turn the scooter power off. Open the battery cover and get out battery.
2. Securely plug the charger into the charge port, and plug to power supply.
3. Connect battery to charger tell you hear a "click".
4. A solid red light on the charger indicates the battery is charging. A solid green light
indicates the battery is fully charged.
5. Remove the plug from the power supply, then remove the battery from charger.
6. You will not damage the battery by riding the scooter until the battery is fully discharged and
the scooter motor shuts down.
BATTERY USE AND CARE WARNINGS
1. Battery must be fully charged before first use.
2. Plug the charger into a 110-240 AC outlet, a red light should appear on the charger. Charge
the battery until the light on the charger turns solid green.
3. Always charge the battery at room temperature. If the battery is used in a cold environment,
allow it to warm up for at least an hour before charging. Cold batteries will not be charged
completely and battery components may be damaged.
4. Only charge battery in well ventilated area away from flammable materials such as cloth or
carpeting.
5. To disconnect charger, remove the plug from outlet, then disconnect the charger from the
battery.
6. DO NOT leave the charger being connected to the battery for more than 24 hours.
7. The battery status indicator is mounted on the top of the battery to allow you to observe the
level of the battery power while in use. To check the charge level, simply press the indicator
button. The lights on the status indicator show the charge level of the battery.
EN13