Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Make sure the voltage is correct according to the plug label.
2.
Make sure all switches are 'OFF' or 'O' .
3. Put the machine on a firm level surface and plug into the power source correctly.
4. Ensure the blender jar, lid, fill cap and tamper are clean and prepare your ingredients before
operation.
1.
Placing materials into the blender jar.
a) Place soft materials or liquids in first, then hard materials or ice in last. Large ingredients
should be sliced or broken into chunks before being placed in the jar for better blending results.
b) Most ingredients should be started on a low speed then changed to medium or high or started
with the timer. If the ingredients get stuck you can press 'PULSE' 2 or 3 times to refresh and
then use the tamper to help blending.
2.
Place the lid tightly on the blender jar.
3.
Put the blender jar onto motor base correctly.
Manual speed series:
1. Keep a safe distance between the operator and machine(about 20CM) when beginning to blend.
2. Press the power switch to ON
3. Choose the LOW or HIGH speed for operating after starting.
4. Switch to OFF, the machine will be shut off.
Under the state of high speed by 5 minutes,it must be stoped 1 minute.
When using the mixing rod,take off the fill cap first and then insert into the cap lid.
PARTS DESCRIPTION
PREPARATION
PLACING INGREDIENTS
STARTING
1
Fill cap
2
Lid
3
Jar
4
Blades assembly
5
Retainer Nut
6
Drive socket
7
Overload protection (Put on back)
8
Pulse switch ( Max power)
9
Tamper
10 Centering pad
11 Power switch
12 Variable speed
6
Werbung
Inhaltsverzeichnis
