Fluid R - DVI Serie Montageanleitung Seite 14

G
B
LEFT UNIT
INTERNAL VIEW
1 - Release for manual operation.
2 - Valve for closing force adjustment.
3 - Valve for opening force adjustment.
F ORCE ADJUSTMENT
Use a screwdriver to increase the force by rotating clockwise the opening valve (grey) and the
closing valve (yellow) located above the operator.
Decrease the force by rotating anti-clockwise the opening and closing valves.
WARNING: When adjusting the force, smoothly and gradually rotate the valves without screwing
them or unscrewing them completely. We suggest to you to adjust the valves in a way
that the pressions are not different between themselves. Adjust the opening pressure
a little higher than the closing pressure.
MANUAL OPERATION WITH HEXAGON KEY
- Remove the pressure inserted cap
- Insert the key into the unlocking device and rotate it for at least a full turn counterclockwise
without forcing it
- Carefully, manually operate the gate.
- Reset automatic operation by completely rotating the key (2) clockwise until it stops.
ELECTRICAL SAFETY DEVICES
The installation must be installed according to the current regulations and laws.
Use the T2 electronic control board (for one or two single-phase motors).
For connections and technical data of accessories refer to the appropriate booklets.
MAINTENANCE
To be undertaken only by specialized staff after disconnecting power supply.
Lubricate the hinges and check the oil level and thrust force generated by the operator on the
gate once a year.
4 - Valve for adjustment of rotation (each one
reduces the stroke by 0°÷ 30°).
5 - Jack.
14
RIGHT UNIT
INTERNAL VIEW
6 - Hydraulic control unit.
7 - Power supply cable.
9
10