Pico Technology PicoScope 4225 Schnellanleitung Seite 6

PicoScope 4225 and 4425 Automotive Scopes
WARNING
To prevent injury or death, the oscilloscope must not be directly connected
to the mains (line power). To measure mains voltages, use a differential
isolating probe specifically rated for mains use, such as the TA041 listed
on Pico Technology's website.
CAUTION
Exceeding the overload protection range on any connector can cause
permanent damage to the oscilloscope and other connected equipment.
Grounding
WARNING
The scope's ground connection through the USB cable is for measurement
purposes only. The oscilloscope does not have a protective safety ground.
External Connections
Power Supply Options
Models USB 2.0 Powered
PicoScope 4225
PicoScope 4425
For maximum performance the PicoScope 4225 and 4425 automotive oscilloscopes
should be connected to a USB 3.1 port on your PC or laptop. If powering either of
these oscilloscopes from a USB 2.0 port, you may need a TA146 double-headed
USB 2.0 cable, available separately from Pico Technology.
2
USB 3.1 Gen 1 Powered
ü ü
Environment
WARNING
To prevent injury or death, do not use in wet or damp conditions, or near
explosive gas or vapor.
CAUTION
To prevent damage, always use and store your oscilloscope in appropriate
environments.
Storage
Temperature –20 to +60 °C
Humidity
5% to 95% RH
(non-condensing)
Altitude
Pollution Degree
Care of the oscilloscope
The oscilloscope contains no user-serviceable parts. Repair, servicing and
calibration require specialized test equipment and must only be performed by
Pico Technology or an approved service provider. There may be a charge for these
services unless covered by Pico technology's two-year warranty.
WARNING
To prevent injury or death, do not use the oscilloscope if it appears to be
damaged in any way, and stop use immediately if you are concerned by
any abnormal operations.
WARNING
To prevent electric shock, do not tamper with or disassemble the
oscilloscope, case parts, connectors or accessories.
WARNING
When cleaning the product, use a soft cloth and a solution of mild soap
or detergent in water. To prevent electric shock, do not allow liquids to
enter the oscilloscope casing, as this will compromise the electronics or
insulation inside.
Quick Start Guide
Operating Quoted Accuracy
0 to 40 °C 15 to 30 °C
5% to 80% RH -
2000 m
2
DO239-4