Scheppach EPH1200 Original Bedienungsanleitung Seite 17

Controller (3) settings:
Controller positions
LOW 350W
LOW 350W
LOW 350W
LOW 350W
HIGH 700W
HIGH 700W
HIGH 700W
HIGH 700W
OSC+350W
OSC+350W
OSC+350W
Low
Low
OSC+350W
Low
Low
OSC+700W
OSC+700W
High OSC+700W
High
High
OSC+700W
High
OFF
3
Using the angle adjustment (2) you can choose
between an oscillation of 120° or 360°.
8. Transport
m Warning! Always unplug the mains plug from the
mains before moving the heater.
Use the transport handle (1) to transport the radiant
heater.
9. Cleaning and maintenance
m Warning!
Pull out the mains plug before carrying out any adjust-
ments, maintenance or repair work!
This heater contains no moving parts; it requires very
little maintenance.
However, if a lot of dirt accumulates on the heater, use
a damp cloth to wipe it off.
WARNING: Disconnect the machine from the power
supply before cleaning and let it cool down for several
minutes.
Function
Heat level:600W
Heat level:1200W
Heat level: 600W
+
Oscillation mode
Heat level: 1200W
+
Oscillation mode
The radiant heater
is switched off in this
position.
www.scheppach.com
Service information
Please note that the following parts of this product are
subject to normal or natural wear and tear, and are
therefore also required as consumables.
Wearing parts *:Heating element, aerator
* May not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
10. Storage
Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 °C.
Store the device in its original packaging. Cover the
device to protect it from dust or moisture. Store the op-
erating manual with the device.
11. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
The packaging is wholly composed of environ-
mentally-friendly materials that can be disposed
of at a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
GB | 17