Scheppach EPH1200 Original Bedienungsanleitung Seite 16

29 Children must be supervised to ensure that they
do not play with the device.
30 This heater must be placed on a horizontal level
floor.
31 If the power cord of this device is damaged, it must
be replaced by the manufacturer, their service de-
partment or a similarly qualified person to avoid
dangers.
32 Do not use this heater with a programmer, timer
switch, separate remote control system or any oth-
er device that automatically turns the heater on,
as there is a risk of fire if the heater is covered or
incorrectly positioned.
33 To avoid electric shock, do not immerse the de-
vice, cable or plug in water or other liquids.
m ATTENTION!
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain conditions. In order to
prevent the risk of serious or deadly injuries, we recom-
mend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the machine.
5. Technical data
Voltage
Frequency
Power consumption (P)
Protection class
Protection category
6. Before commissioning
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
16 | GB
m ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
• Check the device for transport damage. Immediate-
ly report any damage to the transport company that
delivered the device.
• Long supply cables (extension cable) should be
avoided.
• Do not operate the device in damp or wet areas.
7.
m Before connecting the machine to the mains power,
make certain that the data on the type plate matches
with the mains power data.
m Warning!
Always pull out the mains plug before carrying out ad-
justments on the device.
Setting up
• The minimum distances (top: 60 cm, sides: 150 cm)
220-240 V~
must always be observed. The distance must be
50-60 Hz
measured from the surrounding objects to the near-
est point of the heater.
1200 W
• Always keep flammable material away from the
I
heater.
IPX4
• Do not twist or kink the power cable.
• This heater has protection of class IPX4 and is suit-
able for outdoor use. If you need an extension cable,
the cable and plug system must be waterproof.
m Attention! The heater has an anti-tilt protection. If
the heater tilts or falls over, it switches off automatical-
ly.
Operation (fig. 2)
1
Connect the radiant heater to a suitable socket.
2 Settings on the heater can be made using the con-
troller (3) and the angle adjustment (2).
www.scheppach.com
Setup and operation