BASF D 6160 Bedienungsanleitung Seite 8

If using a tape recorder with separate record
and playback heads, you can monitor "after
tape" by turning the TAPE MONITOR switch
(28) from "SOURCE"
to "A". In addition, the
outputs of the recording equipment should be
connected to the TAPE A-IN sockets on the
Receiver, as described later.
(5) TAPE RECORDER A-IN
Connect the outputs of the tape or cassette
deck on which you wish to play back to the A-IN
sockets. To play back the recording, set the
TAPE MONITOR switch (28) onto "A".
(6) TAPE RECORDER B-OUT
The inputs of a second tape or cassette
recorder can be connected to these sockets.
Using the SELECTOR switch (29), select the
source from which you wish to record and for
monitoring, set the TAPE MONITOR switch
(28) onto separate record and playback heads,
after-tape monitoring is possible by turning the
TAPE MONITOR switch (28) from "SOURCE"
to "B". In addition, the outputs of the recording
unit should be connected to the TAPE B-IN
sockets on the Receiver, as described later.
(7) TAPE RECORDER IN-B
Input for a second tape or cassette recorder.
Connect the outputs of the second unit to the
TAPE RECORDER B-IN sockets. For Playback,
set the TAPE MONITOR switch (28) onto "B".
(8) TAPE RECORDER B REC/PB
Proceed as described in (6) and (7).
(9) FM DE-EMPHASIS
(11) MAINS LEAD
Connect the mains lead to your 220 V mains
supply.
(12) AM FERRITE ROD ANTENNA
(13) AM ANTENNA
The AM screw connection is for ribbon or
external AM antenna.
(14) ANTENNA GND (= GROUND)
(15) FM 240/300 OHM ANTENNA
(16) FM 60/75 OHM ANTENNA
In addition to the 240/300 Ohm ribbon antenna
connection, the BASF D 6160 HiFi Receiver also
has a 65/75 Ohm coaxial cable antenna
connection. If you possess such an antenna
cable, connect it to the screw connection
provided.
(17) POWER
(18) PHONES
Connect the jack plug of your headphones to
this socket. If you wish to listen through the
headphones only, make sure that the SPE-
AKERS switch (19) is in the "OFF" position.
Headphones with an impedance of 8-2000
Ohms can be used. However, the most suitable
are those with an impedance of 200-400 Ohms.