Hisense RB645N4BFE Bedienungsanleitung Seite 43

11. Change screw hole covers and screw
on middle cover plate from left to right (as
shown in figure below).
12. Lay the refrigerator on soft foam
packaging or similar material. Remove
both adjustable bottom feet parts③, then
remove the lower hinge part① by
unscrewing screws②.
13.Loose out the lower hinge pin,change it
to the reverse hole site, then tighten it into
position folllow the picture below.
14.Replace the lower hinge part to the left
side and fixing it with the special flange
screws. Replace the adjustablebottom feet
parts to another side and fixing it.
15.Stand the refrigerator upright and
carefully slot the lower door onto the lower
hinge pin and hold in position. Install
middle hinge-left (in the plastic bag)
ensuring the lower door in secured in place.
15
①
②
③
①
Lower hinge part
②
Special flange screw
③ Adjustable bottom feet part
16.Transfer the upper door to the
appropriate position. Secure the door level,
make the middle hinge axis into the lower
hole of the upper door.Install the hinge②
(provided in the plastic bag)by screws①.
Please hold the upper door by hand when
installing.
17.Take out the connector② and③ from
the top left side.Connect① with② ,then
connect③ with the door switch on the
upper hinge cover-left.
① ②
③
18.Install the upper hinge cover② on the
left corner by screw①.
①
Self-tapping screw
②
Upper hinge cover-left
19.Open the upper door and install the
door racks and then close it.
Note:
If your appliance has handle, you have to
reverse handle by follow instructions below.
Lever part① and part④, then loose
screws②. Change handle③ to the right
side, then install screws②, part① and
part④ in turn.
①
②
③
①
Handle cover
②
Special screws
③ Handle
④ Screw hole cover
①
Special flange screw
②
Upper hinge-left
①
②
Door switch
①
②
④