Philips Sonicare ProtectiveClean 5100 Bedienungsanleitung Seite 17

Battery status and charging
1 Put the plug of the charger in an electrical outlet.
2 Place the handle on the charger.
- The charger will emit 2 short beeps to confirm that the handle is
placed properly.
- The flashing light of the battery level indicator shows that the
toothbrush is charging.
- When handle is fully charged on the charger, the battery light
shows solid green for 30 seconds and switches off.
Note: Your toothbrush comes pre-charged for first use. After first use,
charge for at least 24 hours.
Battery status (when handle is not on charger)
When removing the Philips Sonicare from the charger, the battery
light at the bottom of the toothbrush will indicate the status of the
battery life.
- Solid green LED: full battery
- Flashing green LED: medium battery
- Flashing amber LED and three beeps: low battery
- Flashing amber LED and two sets of five beeps: No brushing
sessions left (charge toothbrush)
Sanitizing
- With the UV sanitizer you can clean your brush head after every
use (Fig. 14).
Unplug the sanitizer, discontinue use and call Consumer Care if:
- The UV light bulb remains on when the door is open.
- The window is broken or missing from the sanitizer.
- The sanitizer gives off smoke or a burning smell while it is
operating.
Note: UV light can be harmful to the human eye and skin. This device
should be kept out of reach of children at all times.
1 After brushing, rinse the brush head and shake off excess water.
Warning: Do not place the travel cap on the brush head
during sanitization.
17
English