Werbung
1. Introduction
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
•
Damage caused by user modifications to the device is not covered by the warranty.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
•
Check the contents prior to assembly. Use proper tools and never use defective or deformed
parts as an improper installation may cause serious injury.
•
Any included hardware is for mounting on solid brick, concrete or hard wood battens.
When mounting on wood, do not use any concrete anchors. Do not use any included hardware
for mounting on steel. If uncertain about the nature of the wall or mounting techniques, please
consult an expert.
•
Respect the product's max. load specifications. Protect this device from shocks and abuse and
avoid brute force when operating. Check the installation on a bimonthly basis.
•
An adequate mounting is essential and falls outside the responsibility of Velleman nv. Respect all
installation and operating directions of the device to be mounted/installed (LCD/plasma display).
•
Only use the device at an indoor location, protected from rain, moisture, splashing and dripping
liquids. Make sure the chosen location spot is able to support the weight of the bracket and
screen.
•
Keep fingers away from articulations to avoid injury. Keep the device out of reach of children and
unauthorized users at all times.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Features
• for LCD TV
• easy installation
• in accordance with VESA standard max. 600 x 400mm
• comes with all necessary plugs and screws for assembly and mounting
5. Installation
Refer to the illustrations on pages 2 and 3 of this manual.
1) Use the wall mounting bracket to determine and indicate the position of the mounting holes.
1a) When mounting on a brick or concrete wall, drill holes size Ø10mm and at least 60mm deep
at the indicated positions. Insert the included anchors and mount the bracket with the
included screws.
1b) When mounting on a wooden wall or wall support, drill holes size Ø3mm and at least 60mm
deep at the indicated positions. Make sure all the holes are blind holes. Mount the bracket
with the included screws.
2) Mount the TV mounting bracket on the back of the TV as close as possible to the centre and
aligned with the top of the TV-screen. The safety bolt must face the bottom of the TV.
Depending on the TV screen; use the correct bolts together with the correct washers. Make
sure that the threaded inserts of the TV are deep enough to tighten the bolts without
damaging the TV.
3) Hook the TV mounting bracket over the wall bracket.
4) Use the included hex key to secure both safety bolts. Screw them in as far as possible.
5) To change the vertical angle of the TV-screen, loosen the turning knobs (see figure 2 - A),
move and hold the screen into the desired angle and tighten the turning knobs. To secure the
angle setting, use two 13mm spanners (not incl.) to tighten the four bolts and nuts (see figure 2
- B).
29/04/2011
WB026
Figure 1
User manual
4
Rev. 01
© Velleman nv
Werbung
