Herunterladen Diese Seite drucken

CombiSteel 7455 26 Serie Gebrauchsanweisung Seite 6

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Do not throw items onto the shelves and
do not place items totalling more than
30kg on each shelf. The shelf could fall
down, possibly causing injury or break the
shelf itself.
HOW TO USE
Before use
Remove shipping package, tape, etc. Also leave the door(s) open for ventilation for a while.
The unit is cleaned before shipment. However, clean the compartment interior once after delivery.
Please insert power supply plug into the wall outlet, single-phase to cat voltage.
Allow the unit to operate for about 1 hour to cool the compartment before placing items in the freezer.
WAIT 5 MINUTES OR MORE BEFORE RE-STARTING
Restarting the unit immediately after it has been turned off may cause fuses to blow and activate the circuit-
breaker, thus, the compressor may be overloaded and/or other damage may occur.
Temperature adjustment
Thermostat was adjusted using temperature at factory. To adjust it, turn right could cause temperature in
showcase to go down. To raise the temperature, turn it left. Excessive refrigeration will increase electricity
consumption unnecessarily.
Drain tray
Defrosting is performed automatically and drain water is collected in the drain tray.
Water in the drain tray evaporates automatically by compressor hot gas. In humid surroundings, there will
be large amounts of water in the drain tray, so please throw away drain water at least once a day.
Efficient use
Please follow the instructions below, to save energy.
To prevent cold air from escaping, open and close the door(s) quickly and keep the door(s) opened for as
short a time as possible.
Please install the unit in the place which is well-ventilated.
Placing items in the showcase
This showcase employs a natural circulation of cold air system. If circulation of cold air is obstructed, the items
will not be adequately frozen. Pay attention to the following points:
Do not let items obstruct the cold air inlet and suction outlet.
Place items so that they do not protrude from the shelves. The gap between the shelves and the door(s) is
used for circulation of cold air.
Place items evenly on all shelves.
Please do not display goods on the bottom. Please put goods on the shelf.
Place items underneath the loading line, otherwise the items will melt.
Be sure to attach and secure shelves
correctly. An improperly attached shelf
could fall down and cause injury or break
the shelf.
6

Werbung

loading