Herunterladen Diese Seite drucken

Schildmeyer Flag 803360 Aufbauanleitung Seite 6

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
EN
Dear Customer, the item must be assembled exactly in accordance with the manufacturer's instructions. Otherwise, possible assembly
errors may pose a safety risk and result in the loss of the guarantee. Please use a soft surface for installation (e.g. a blanket) in order to avoid
scratches. Keep these assembly instructions and pass on with the unit. These assembly instructions can also be obtained from our customer service
department as a PDF file.
Intended use: This furniture is designed exclusively for use in private households.
Assembly instructions: Before drilling it is essential to check and take into account the position of electricity cables and water pipes! In the
case of wall installation it must be ensured that the unit is not mounted on conducting surfaces and only on solid masonry. The installation material
supplied is suitable for standard, solid masonry. Before wall installation please check which installation material is suitable for your wall and exchange
it if necessary.
Note on electrical installations: Only a qualified electrician may establish the electrical connection in compliance with national regulations
in force, e.g. DIN-VDE regulation 0100, part 701, IEC 60364-7-701 or HD 60364-7-701. We do not accept any liability in case of non-observance of the
national regulations. Please note that the item may only be installed in a bathroom outside protection areas 0 to 2 in accordance with the aforemen-
tioned VDE rule. In rooms fitted with a bath or shower, the circuit must have a residual current operated device (RCD) with a rated value of not more
than 30 mA.
Note on LED lighting: The LED lamps used have an extremely long service life of over 30,000 hours, which is why there is no provision for
replacing the lamp. In the event of a defect, either the power supply or the luminaire must be replaced. In such cases please contact our service
organisation. This lighting equipment is not suitable for operation with a dimmer switch! This product contains an energy efficiency class "G" light
source.
Disposal: The packaging consists of recyclable materials. Please dispose of the packaging in accordance with your valid local regulations
in an environmentally friendly manner. At the end of its useful life, do not dispose of the product with the household waste. Please remove all
electrical components from your item of furniture before disposal. Ask your communal administration for possibilities of an environmentally sound
disposal.
Maintenance instructions: Please regularly check and tighten all screwed connections. Loose connections may cause a safety risk.
Care instructions: Always use soft, slightly moistened cloths or shammies to clean your furniture. Make sure that all parts are wiped dry
after use or cleaning. Avoid abrasive substances or substances containing solvents and do not use microfibre cloths. Please note that some highly
concentrated cosmetics can cause damage to the material if they are not wiped off immediately. Remove any surrounding moisture immediately
and avoid allowing condensation to build up. Because such damage is not covered by the guarantee, we would ask you to follow these instructions
carefully to ensure that you enjoy your product for many years to come. For care instructions for the individual materials, please visit our homepage
at: www.w-schildmeyer.de
Explanation of symbols: The following symbols are used in these installation instructions:
This signal indicates a medium hazard which, if not averted, may result in death or serious injury.
This signal warns of possible property damage.
This signal gives you useful additional information on installation or use.
Before connecting/installing or switching on the item of furniture, it is essential to note the symbols shown on the type plates.
Protection class 1
Protection class 2
Protection class 3
Replace any broken glass cover.
The light source of this lamp is not replaceable. When the light source
has reached the end of its life, the entire lamp must be replaced.
The product must not be disposed of via household waste.
The marked components must be removed before the furniture
is disposed of. Please note the disposal instructions and the
dismantling instructions on page 27 in this connection.
06
Warning! Keep small parts, packaging bags and film out of reach of
babies and small children. Risk of suffocating and swallowing!
Always follow the assembly instructions!!
V08/2022

Werbung

loading