Klarstein Bellevin 18 Uno Bedienungsanleitung Seite 13

USE AND OPERATION
• The temperature is adjusted in the range of 1 1-18 °C in the cabinet.
• When the power is connected, cooling system starts to work.
• The temp you want can be set by touching the "set temp up button" and "set temp
down button" with your finger. When the inside temperature higher than the set
point Cooling system will be work normally. When the inside temperature lower
than the set point, cooling system stop working. And the inside temperature will be
rise. When it raises above the set point, Cooling System starts to work again.
• The Light can be turned OFF or ON by touching the "Light button".
TROUBLESHOOTING
Symptoms Possible Cause
• Plug not put in
No cooling • Low voltage
• Fuse broken
• The refrigerator is
placed too close to a
heat source;
• Bad ventilation;
• The refrigerator is
Temperature placed too close to a
inside not cold heat source;
enough • Bad ventilation;
• Fans don't work;
• The door is not closed
tightly or opened too
frequently or for too
long time;
Peculiar smell • Check whether there is
inside anything sour inside
• Too much humidity or
Frost on the
too low temperature
cold sink
inside the case
Solution
• Put in the plug
• Ensure normal voltage
• Change fuse
• Keep the refrigerator away
from sunshine or other heat
source;
• Place the refrigerator in the
area with good ventilation
and keep things away from
the fans;
• Check whether the plug is
connected or change the fan;
• Close the door tightly and
don't open the door too
frequently or for too long time.
• Wrap the source or take it out
• Output the plug, stop the
power, and defrost by hand,
connect power again when
the ice thaws
EN
13