Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Feet
8. Heating wire backup
9. Heating element
ASSEMBLY OF THE HEATER
Before using the heater，the feet（supplied separately in the
cartoon，must be fitted to the unit. These are to be attached to the
base of the heater using the 4 self-tapping screws provided，taking
care to ensure that they are located correctly in the bottom ends of the
heater side moldings.
WALL MOUNTING
Convector has the option of wall mounting, assembly should take place using the fasteners
attached to the device - as shown in the diagram below.
See picture 1
1. Fixed by screw
OPERATION OF THE HEATER
Note：It is normal when the heaters are turned on for the first time or when they are turned
on after having been used for a long period of time the heaters may emit some smell and
fumes.This will disappear when the heater has been on a short while.
- Choose a suitable location for the heater，taking into account the safety instructions
above.
- Insert the plug of the heater into a suitable socket.
- Turn the thermostat knob fully in a clockwise directions to the maximum setting.
- Turn on the heating elements by means of the rocker switches on the side panel. When
the heating elements are on the switches will illuminate. For maximum heat output both
switches should be on.
- When the desired room temperature has been reached，the thermostat knob should be
turned slowly anti-clockwise until the thermostat is heard to click off and the lights on the
elements switches are seen to go out. After this the heater will keep the air temperature in
the room at the set temperature by switching on and off automatically.
Control panel See picture 2
1. Heater switches
16. Timer cover (CH6000 only)
17. Timer (CH6000 only)
10
Werbung
