SUHNER MACHINING WS Original Bedienungsanleitung Seite 19

The motor cable is mounted at the angle plug of the ser-
vo motor and tightened by hand. The angle plug can be
turned.
2.4 r
Ating dAtA
Max. wheel Ø
Spindle thread
IP protection motor
Paint coating
Belt drive transmission
s t n086-3-F
erVOmOtOr ype
Motor output rating
Nominal motor current
Torque at motor speed 3500rpm
Torque at max. motor speed 7000rpm
Weight machine
s t ln086-4-e
erVOmOtOr ype
Motor output rating
Nominal motor current
Torque at motor speed 2500rpm
Torque at max. motor speed 5000rpm
Weight machine
2.5 O
perAting cOnditiOns
Room temperature: +5°C to +50°C.
Relative air humidity: +30°C 95% / +50°C 65%. The partly
completed machinery must be protected against direct
spray and/or pressurized cutting fluids.
3.1 p
Artly cOmpleted mAchinery
3.1.1 c
hAnging the Belt
178mm
M14 Loosen screws and remove the plate and cover.
IP 65
RAL5012
i=1:1
0.94kW
4.7A
3.25Nm
2.8Nm
6.6kg
1.5kW
By loosening the screw with a hexagon spanner, the mo-
6.4A
tor lowers and the belt can be replaced. To install, follow
3.8Nm
the above instructions in reverse order.
2.9Nm
7.5kg Keep the partly completed machinery clean! Note
the correct belt tension (see point 4.3)!
3.2 g
rinding
Use only grinding tools whose admissible maxi-
mum speed is equal to or higher than the no-load
speed of the partly completed machinery. Use
only clean tools! Never remove chips with your bare hand,
but always use e.g. hooks, etc. See the SUHNER main
catalogue for tools and adapters.
3. h /o
aNDlINg PERaTIoN
t
OOls
19