Operation - Wolf Garten SDE 2100 Gebrauchsanweisung

Operation

Times of operation
Please consult regional/local regulations.
Inquire about the operating times at your local regulatory
agency.
Connect to the socket (230 Volt, 50 Hz)
Only connect the equipment to sockets which are shielded
with a 16 Amp. fuse (inertial or LS switch type B).
3
Note: Residual current protection device
These safeguards provide protection against severe inju-
ries resulting from touching damaged cables, insulation de-
fects and in some cases cables that conduct electricity.
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of no
more than 30 mA.
Retrofit kits are available for old installations. Consult an
electrician.
Working with the garden chopper
1
Wear protective gloves and hearing protection!
Adopt a working position at the side of or behind the appli-
ance. Never stand in the area of the discharge opening.
Never put your hands in the feed or discharge opening.
Before switching on the appliance check whether there is any
chaff in the hopper.
If foreign bodies should enter the hopper or should the appli-
ance make unusual noises or vibrations, switch the appliance
off immediately and allow it to come to a standstill. Remove
the mains plug and carry out the following:
–
Check the appliance and tighten any loose parts.
–
Replace damaged parts.
–
Repairs to the appliance must be performed by an author-
ised service centre.
What can be chopped
Organic waste from the house and garden e.g. hedge and tree
cuttings, dead flowers, kitchen scraps.
What cannot be chopped?
Glass, metal parts, plastics, plastic bags, stones, material
waste, roots with earth, food, fish and meat waste
G
Switching on / off
Press the green button to switch on
Press the red button to switch off
3
The machine has a circuit breaker to prevent switching
back on unintentionally after a power cut.
Overload protection
3
An overloading of the appliance (e.g. culminating in the
blocking of the blades) can lead to the standstill of the
appliance after a few seconds. To protect the motor
from damage the appliance is automatically discon-
nected from the mains by the overload protection.
Before putting into operation again wait for at least one
minute before immediately pressing the reset button
and then ON/OFF switch. If the motor does not start,
clean the collection hopper (see Maintenance).
Special instructions for chopping
Chop branches, twigs and wood shortly after cutting (this
chopped material will become very hard once it has dried out,
therefore the maximum diameter which can be processed is
less).
Remove the side shoots on severely ramified branches.
When processing garden or kitchen waste with a high water
content with a tendency to stick, crush alternately with wooden
chopping material to avoid blocking the appliance.
Do not allow the chopping material in the area of the discharge
opening to accumulate too high. This can lead to material
which is already chopped blocking the discharge channel.
This can cause a kickback of the material through the filling
opening.
Ensure that the maximum branch diameter for processing per-
mitted for your appliance is observed.
The blade unit pulls in the chopping material largely by itself.
Do not overload or block the motor in the case of tough
branches by frequently pulling back the branch.
B
C
A
11