Stalgast 9705100 Bedienungsanleitung Seite 21

Short-circuit of the surface
temperature sensor or overheating
of the work surface
d
The device temperature sensor is
A
defective
Short-circuit or excessive
temperature of the IGBT
C
temperature sensor
Open circuit of the IGBT
B
temperature detector
Resonant circuit of the induction
n
coil, short-circuit protection
— – IGBT over-current protection
—
10. DISPOSING OF USED EQUIPMENT
Information for users about the proper principles of disposal of waste electric and electronic
equipment
•
Leave the old device in the store where you are buying a new device. Each store has an obliga-
tion to take your old equipment free of charge if you buy new equipment of the same type and in the
same quantity. The only condition is to deliver the equipment to the store at your own expense.
•
Take the used device to a collection point. You will find information about the nearest location on
the municipal website or bulletin board of the municipal office.
•
Leave the device at the service point. If the repair of the device is uneconomical or impossible for
technical reasons, the service is obliged accept the device free of charge.
•
Return used equipment without leaving your house. If you don't have the time or ability to trans-
port your equipment to a collection point, you can use the services of specialized companies.
Remember! Do not dispose of used equipment along with household waste.
This could cause high fines.
The symbol of the crossed-out waste bin on the product, its packaging or the instruction
manual means that the product should not be disposed of to normal waste bins. The user
is obliged to hand over the used equipment to a designated collection point for proper
processing.
11. WARRANTY
The seller shall be liable under the warranty or guarantee.
Damage resulting from the formation of lime scale deposits in the device are not subject to repair under the
warranty.
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements
damaged by lime scale, screws and elements undergoing natural wear, e.g. rubber seals and all kinds of
mechanically damaged elements. Any damage of components resulting from improper use is also excluded
from the warranty.
The warranty is automatically voided in the event of a broken warranty seal or independent repairs.
In the case of overheating protection make sure the
air inlet and outlet are not blocked, the fan is not
damaged, the ambient temperature does not exceed
o
40 C, the device does not run without the heat
receiver on dry run
Replace the device temperature sensor
In the case of overheating protection make sure the
air inlet and outlet are not blocked, the fan is not
damaged, the ambient temperature does not exceed
o
40 C
Replace the IGBT temperature sensor
Make sure that the induction coil and the high-voltage
circuit are open
Need to be professionally maintained.
- 21 -