Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation instructions:
1.)
Remove the rear bumper. To do this, take off the lower clips.
At "b" on both the left and right, remove the two lower screws M8 from the bumper
reinforcement flanges.
2.)
3.)
Place the supports 4 and 5 under the vehicle. Push the bore holes "a" onto the threaded bolts
M8 located on the outer side of the longitudinal beams and align them with "b" on the bumper
reinforcement flanges.
Then loosely screw together the supports 4 and 5 at "a" with the washers 8.5x24x2 and nuts
M8 and at "b" with the washers 8.5x24x2 and screws M8x40.
4.)
Place the basic frame 1 under the vehicle and position it between the supports 4 and 5.
Then loosely screw the basic frame 1 to the supports 4 and 5 at "c" with the screws M 12x40
and washers 13x24x2.5 as well as at "d" with the screws M12x40, washers 13x24x2.5 and
nuts M12.
5.)
Push the ball bar 2 between the plates at "e" and loosely screw together with the screws
M12x65, washers 13x24x2.5 and nuts M12.
The socket holder 3 is also attached here.
6.)
Align the trailer hitch and tighten all screws and nuts.
Torque for M8
Torque for M12
Torque for M12
7.)
Secure the bumper by reattaching the clips.
at "a", "b"
20 Nm
at "c", "d"
65 Nm
at "e"
95 Nm
GB
Subject to changes.
19
Werbung
