Whispbar K976W Montageanleitung Seite 9

EN
Fitting Kit
K976W
Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
Fitment Rear Bar Only
Place washer onto the capscrew.
Place clamp over the mounting hole
Attach capscrew with the Hex Key. Do not
fully tighten.
Leave loose until both sides have had the
screw fitted.
Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
9