EuroLite LED D-30 Hybrid Beam Effect Bedienungsanleitung Seite 26

13 channel mode
Channel:
1
2
3
4
5
6
7
8
3W Strobe
9
Rotation
10
SMD Strobe
11
SMD Strobe
12
Programs via DMX
13
Speed via DMX
EUROLITE IR-7 remote control
Value: Function:
000 - 255 Dimmer
000 - 255 Red
000 - 255 Green
000 - 255 Blue
000 - 255 White
000 - 255 Amber
000 - 255 Pink
000 - 009 No function
010 - 255 3W LED Strobe with increasing speed
000 - 180 Clockwise rotation
181 - 255 Back and forward movement with increasing speed
000 - 009 No function
010 - 099 Left side SMD LEDs
100 - 199 Right side SMD LEDs
200 - 255 Left and right side SMD LEDs
000 - 009
No function
010 - 255
SMD Strobe with increasing speed
000 - 009 No function
010 - 199 Auto mode via DMX
200 - 255 Sound mode via DMX
000 - 255 Increasing speed in Auto /Sound modes via DMX
1
The device must be activated for remote control. For this,
under menu item InFr, press the ENTER button to confirm
activation.
2
When actuating a button, always hold the remote control in
the direction of the sensor. There must be visual
connection between the remote control and the sensor.
3
The remote control is supplied with a battery inserted. An
insulating foil between the battery and the battery contacts
prevents the battery from being discharged during storage.
Prior to the first operation remove the foil from the battery
support on the rear side of the remote
control. Otherwise operation of the remote
control is not possible.
4
If the range of the remote control decreases
(10 meters as a maximum), replace the battery. For this
purpose, on the rear side of the remote control press the
small bar with the groove to the right and at the same time
remove the battery support. For operation, one 3 V button
cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows
upwards in the support.
26/28 00093754, Version 1.0