Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4
XLR occupation:
1: Ground
2: Signal (-)
3: Signal (+)
DMX IN
DMX OUT
6
INSTALLATION
Overhead rigging
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property.
5
Safety rope
Mic
MODE UP DOWN ENTER
Fuse:
LED D-30 Hybrid Beam Effect
No. 51918310,
EAN
4026397551419
F 1 A, 250 V
10
0-240V 50/60Hz
~ 36W
F1A,250V
T =45°C
T =60°C
0.1m
a
C
Steinigke Showtechnic GmbH Andreas-Bauer-Str. 5
97297 Waldbuttelbrunn Germany www.steinigke.de
Power supply:
100 - 240 V AC, 50/60 Hz ~
7
8
9
10
11
DANGER TO LIFE!
4
12
21/28
(4) Fixation screws
(5) Mounting bracket
(6) DMX-In plug
(7) DMX-Out socket
(8) LED Display with 4-button
operation
(9) Microphone
(10) Fuseholder
(11) Power supply
(12) Attachment eyelet
00093754, Version 1.0
Werbung
