Herunterladen Diese Seite drucken

ESX Signum Serie Bedienungsanleitung Seite 11

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
FIGURES
(P. 28-31)
CONNECTIONS AND CONTROLLERS (FIG. 1)
(1)
Power-/Protection-LED
(2)
HIGH PASS controller CH1/2
(3)
Selector HP (Highpass) – FULL CH1/2
(4)
LEVEL INPUT controller CH1/2
(5)
LINE INPUT CH1/2 & CH3/4
(6)
LEVEL INPUT controller CH3/4
(7)
Selector INPUT MODE 2CH/4CH
(8)
HIGH PASS filter controller CH3/4
(9)
Selector HP (Highpass) – FULL – LP/BP (Lowpass/Bandpass) CH3/4
(10) LOW PASS / BAND PASS controller CH3/4
(11) BASS BOOST controller CH3/4
POWER SUPPLY AND TURN ON CONNECTION (FIG. 2)
(1)
GND terminal for the ground
(2)
REM terminal for the turn on connection
(3)
+12 V terminal for the positive-connection of the battery
(4)
Vehicle's battery
(5)
In-Line Fuse (not included in the scope of delivery)
(6)
Turn on wire from the head unit or the electrical antenna
(7)
In-Line Fuse 120 A (included in the scope of delivery)
4-CHANNEL OPERATION STEREO (FIG. 3)
If you want to run the amplifier with the 4 line output channels* from the head unit to drive four loudspeakers in
stereo, connect the following setup:
(1)
To the head unit, line output left FRONT L/CH1
(2)
To the head unit, line output right FRONT R/CH2
(3)
To the head unit, line output left REAR L/CH3
(4)
To the head unit, line output right REAR R/CH4
(5)
Loudspeaker left REAR L/CH3
(6)
Loudspeaker right REAR R/CH4
(7)
Loudspeaker left FRONT L/CH1
(8)
Loudspeaker right FRONT R/CH2
3-CHANNEL OPERATION STEREO & MONO (FIG. 4)
If you want to run the amplifier with the 4 line output channels* the head unit to drive a pair of loudspeakers and
a subwoofer, connect the following setup:
(1)
To the head unit, line output left FRONT L/CH1
(2)
To the head unit, line output right FRONT R/CH2
(3)
To the head unit, line output left REAR L/CH3 or subwoofer output
(4)
To the head unit, line output right REAR R/CH4 or subwoofer output
(5)
Loudspeaker left FRONT L/CH1
(6)
Loudspeaker right FRONT R/CH2
(7)
Subwoofer
* If your head unit only has two output channels, connect CH1 and CH2 and set the switch INPUT MODE to
position 2CH.
11

Werbung

loading

Diese Anleitung auch für:

Signum sxe250.4