Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.1 Installation
Before the installation take away the equipment from its packing. Some pieces are protected with a plastic film that must
be taken away with care. If some residuals of glue remains on the surfaces take care to remove it acting with right
substances, like gasoline, and never with abrasive substances.
Fit up the feet on the equipment. The equipment must be leveled (the feet are adjustable for height). Make sure of the
backing plate solidity.
The master switch or the socket must be near the equipment and within easy reach. The installation of an exauste hood
over the equipment is advisable. Take care to observe all fire-fighting law prescriptions.
2.2 Law prescriptions regulations - instructions
The installation must be executed complying the following rules:
-
Accident preventions rules in force.
-
Prescription VDE in force.
2.3 Installation
Installation, start-up and maintenance of the appliance must be performed by qualified staff. All work required for
installation must be performed in accordance with the laws in force. The manufacturer declines all responsibility in the
event of malfunctioning due to incorrect or non-conforming installation.
CAUTION! As per international regulations, during connection of the appliance a device is to be provided upstream of the
same in order to disconnect the appliance, on an omnipolar basis, from the mains. This device must have an opening of
the contacts of at least 3 mm.
2.4 Electrical connection
The connection cable chosen must have the following features: it must be at least H05 RN F and with an adequate
section for the appliance. The junction-boxes are located on the right the equipments. Pass over the cable and connect
the electrical conductors in the corresponding terminal and fix. The earthed neutral must be longer than the others so in
case of breakage of the cable fastener it will come off after the electrical conductors.
EQUIPOTENTIAL The appliance is to be connected in an equipotential system.
CAUTION! The manufacturer is not responsible, and does not compensate under guarantee, damage caused by
inadequate installations not conforming to the instructions.
ATTENTION: Appliance fonctionment must be only done under surveillance.
Before starting up the appliance, load the basin with water by proper tap until to cover the bottom (at least 3 cm of water).
3.1 Turning
Active the appliance by the switch situated above itself,
turn the knob and choose the temperature. Pilot light
signals that water is gotten at right temperature. Check
always that water should be in the basin.
Electrical resistance situated under the basin is locked
by a thermostat of security; therefore, if the appliance
should be working without water or for other troubles,
intervention of security device assures bain-marie block.
In this case, the restoration of security thermostat is
automatic and it happens when the temperature fell. If
you often repeat the blockade of you are advised to
consult the technical assistance.
3.2 Shutdown
Turn knob to position "0".
Switch off the circuit breaker.
3.3 Draining the water
Switch off the appliance
Make sure that the water in the frying compartment is cold.
Operate the safety lever inside the appliance under the basin.
2. INSTALLATION
3. OPERATING INSTRUCTIONS
6
Led light
Knob
Switch
Fig. 1
Werbung
