Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
GENERAL INSTRUCTIONS
2.
INSTALLATION
2.1
Installation
2.2
Law prescriptions regulations - instructions
2.3
Installation
2.4
Electrical connection
3.
OPERATING INSTRUCTIONS
3.1
Turning
3.2
Shutdown
3.3
Draining the water
4.
MAITENANCE
4.1
Cleaning and care
4.2
Action in the case of prolonged disuse
4.3
Action in the event of a fault
4.4
Maintenance
5.
LIST OF MODELS
Wiring diagram
Read the instructions contained in this handbook carefully as they give important advice concerning safety of installation,
use and maintenance.
Keep this handbook for any further consultation by the various operators.
After having removed the packing, make sure the equipment is intact. In case of doubt, do not use the equipment and
contact professionally qualified staff.
Before connecting the equipment, make sure that the rating corresponds to that of electricity mains.
The equipment must only be used by staff trained in use of the same.
Before carrying out cleaning and maintenance, disconnect the equipment from the electricity supply system.
Switch the equipment off in the case of a fault or malfunctioning. For any repairs only contact an authorised technical
service centre and request the use of original spare parts.
Failure to observe the above may jeopardise safety of the equipment.
Connection, installation of the system and appliances, ventilation and fumes extraction must be carried out according to
the manufacturer's instructions, by professionally specialised staff.
The electrical safety of this equipment is only ensured when it is correctly connected to an effective earthling system as
laid down by current electrical safety regulations.
This fundamental safety requirement has to be checked and, in case of doubt, an accurate check on the system by
professionally qualified staff requested. The manufacturer cannot be considered liable for any damage caused by failure
to earth the system.
This equipment must only be used for the purpose for which it was specifically designed.
Do not wash the equipment with direct, high pressure jets of water.
Do not obstruct the openings or vents for extraction or release of heat.
So as to avoid the risk of rust or chemical attack in general, the stainless steel surfaces have to be kept properly clean.
Clean the parts in stainless steel daily with warm, soapy water, then rinse thoroughly and dry carefully.
On no account should the stainless steel be cleaned with steel wool pads, brushes or scrapers in standard steel, in that
they could deposit ferrous particles which, by oxidising, cause rust spots. Stainless steel wool can, if necessary, be used
in the direction of the satin finish.
If the equipment isn't in use for long periods, wipe all the steel surfaces vigorously with a cloth moistened with Vaseline oil
in order to apply a protective layer; also air the rooms periodically.
The manufacturer of the appliance declines every responsibility for possible mistake contained in this booklet imputable to
printing or transcription errors. It also reserves the right to bring changes to the product if retains useful or necessary
without jeopardizing the essential characteristics.
The manufacturing company declines any and every responsibility if the rules brought in this manual are not strictly
observed.
The manufacturer of the appliance declines all responsibility for damage caused by faulty installation, tampering with the
appliance, improper use, poor maintenance, failure to observe local regulations and unskilled use.
THE DISCHARGE OF MACHINE WHEN NO MORE OF USE MUST BE DONE IN COMPLIANCE WITH LAW. THE
MACHINE MUST BE DELIVERED TO FIRM AUTHORIZED FOR THE DISCHARGE OF MACHINE AND OF ITS
COMPONENTS.
CONTENTS
1. GENERAL INSTRUCTIONS
5
Pag. 5
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 6
Pag. 7
Pag. 7
Pag. 7
Pag. 7
Pag. 7
Pag. 7
Pag. 14
Werbung
