Faults; Repair; Disposal - ITW SIMCO-ION HDC Bedienungsanleitung

9. Faults

Table 1: faults
Problem
No charging
Insufficient charging
Spark-over from charging
bar to material

10. Repair

Warning:
 Repairs shall be made by a skilled electrical engineer.
 When carrying out work on the equipment: De-energise the equipment.
Except for the cable protection the charging bar does not have any parts which may be
replaced by the customer. Simco-Ion recommends to return defective bars.
Request an RMA form by sending an e-mail to service
Pack the bar properly and clearly state the reason for return.

11. Disposal

Adhere to the applicable local environmental and other rules when disposing of the product.
HDC/HDR_UM_9752092810_NL_D_GB_F_V2_1
Cause
High voltage power unit
not switched on
High voltage power unit
defective
HV cable interrupted
High voltage set too low
Charging current not set or
set too low
Distance from charging bar
to material too large
Charging bar fouled
High voltage set too high
Distance from charging bar
to material too small
Remedy
Switch on the high voltage
power unit
Repair the high voltage
power unit
Restore HV cable
Raise high voltage
Set (or raise) charging
current
Mount the charging bar
closer to the material
Clean the charging bar
Lower high voltage
Mount the charging bar
farther away from the
material
simco-ion.nl.
@
18