Herunterladen Diese Seite drucken

cecotec IRONHERO 1800 FORCE Bedienungsanleitung Seite 36

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 43
ENGLISH
Wait for 40 seconds: the indicator light will turn off, showing the preheating end. Next,
-
press the steam button to start using the iron.
Note: intermittent switching on and off of the indicator light is normal and indicates correct
operation of the temperature control.
After use, press the steam button to stop the steam, unplug the appliance, let it cool
-
down and store it in a dry place out of the reach of children.
Pump protection system: If the water tank is empty, the pump will emit a continuous
-
sound and the protection system will activate after 45 seconds to protect the pump.
4. CLEANING AND MAINTENANCE
NOTE
-
Make sure the iron is unplugged from the mains before cleaning.
-
Disconnect the appliance from the power supply and allow it to cool down completely
before cleaning.
-
Remove the brush head and clean the steam outlet with a damp cloth.
Do not use harsh or abrasive cleaning agents or solvents.
-
Do not put the garment steamer in water or any other liquid.
-
Always empty the water tank after each use and rinse with clean water.
-
Clean the housing with a damp cloth.
-
Always ensure the steam outlet hole is clean, free from scaling and not blocked.
-
Once the garment steamer is disconnected from the power outlet, cooled down, water
-
is emptied and the device is clean, it is recommended to wrap the cord safely around the
steamer to store in an upright position.
Cleaning water mineral deposits
To prevent minerals from building up or reduce them, follow the below recommendations:
-
Carry out this process once every month if not using natural water.
-
1. Make sure the appliance is unplugged and cooled down.
2. Mix 50 % of descaling product and 50 % low-mineral or natural water.
3. Remove the water tank as indicated before, open the rubber plug and carefully pour the
solution into the tank. Put the plug back,
4. Leave to stand for 40 minutes and empty the tank after this time.
5. Fill the tank with clean water, rinse and empty. Repeat this step until any odour
disappears.
This process only cleans the water tank.
-
Do not plug the device during this process.
-
36
IRONHERO 1800 FORCE

Werbung

loading