Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When a menu function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
Master mode: any unit cans work for master fixture,
Slave mode: must be setting DMX address value for Slave.
DMX code setting: d1~d512
SET DMX ADDRESS CODE:
1. Enter into the menu by pressing the MENU button. Select d001 via the up and down keys and press ENTER.
Modify the value via the up and down keys. Press ENTER to save and exit, or press the MENU button to exit
without saving.
2. Enter into menu by pressing the MENU button, select among a variety of operating codes via the UP/DOWN
keys. Press ENTER to save and run or MENU to leave the menu and return to the operating modes.
MANUAL SETTING MODE ON LED DISPLAY
Mode
Set DMX address
Select number of chan-
nels
Master-Slave
Sound controlledmode
Sound sensitivity ad-
justment
Automatic mode
Auto effect speed
Color selection
Display inversion
Software version
IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the appliance. Aim
the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in accordance with
your local regulations..
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING :Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.
4
MANUAL - LEDBAR24-RC
Addr
A001
6Ch
ChNd
30Ch
nASt
SL 1
SoUn
So 0
SE 99
Auto
Au 0
Colo
CO1-15
dISP
dSIP
ver
u11
©Copyright LOTRONIC 2023
Display
A512
9Ch
58Ch
SL 2
So16
Se 0
Au16
red
Gree
blue
16Ch
SP 0
SP 9
0 - 255
Werbung
