Werbung
Verfügbare Sprachen
Verfügbare Sprachen
①GAIN
Spin the knob from the left to right, the gyro intervention gains value 0-100%.
②SET
1. Reverse/Normal Switching
When the power on, long press the【SET】3 seconds, the LED from red to green
or from the green to red, it means the switch is successful. (Red LED is on for
Normal, Green LED is for Reverse)
The default direction of servo is Reverse. If not modified, please keep the
!
red constant LED light as normal state.
2. EPA (End point adjustment)
Before setting, please make sure the gyro direction is the same as the
!
direction of vehicle steering.
a. Before power on, press and hold【SET】, then turn on the vehicle power (please release【SET】 ASAP
after turning on the power, if more than 5 seconds, it will restore the factory setting), LED red flashing, it
enters into the EPA setting.
b. Rotate the remote control rudder, turn the rudder to the desired position (to the left or right), keep the
current state, short press【SET】 then the green LED flashing, it completes the single-side EPA setting.
c. Rotate the remote control direction rudder to turn the servo to the desired position in another direction and
keep the current state, short press【SET】and the red and green LEDs will flash (about 2 seconds). When
the LEDs will be on, the EPA setting is finished.
* Restore factory setting: Before power on, press the【SET】, then hold for 5 seconds after power on, the
red LED and green LED will flash at the same time, then return to default setting (default
1100us-1900us).
③LED status
LED
Power on fast flashing
Slow flashing
Red on
Green on
Fast Flashing
Gyro initialization (time about 2 seconds).
No Transmitter signal.
Working，gyro direction is Reverse.
Working，gyro direction is Normal.
In EPA Setting.
- 5 -
Status
Werbung
