Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating Instructions
Changing the Battery
Using a suitable screwdriver, open the
back of the handheld remote control.
Remove the old battery and insert the new
battery (coin cell 2430) making sure that
the symbols match ("+" can be seen at the
top). Dispose of the old battery in an envi-
ronmentally-friendly manner.
Replace the back plate and screw it down
onto the handheld remote control using a
screwdriver.
Troubleshooting
Error
• The drive isn't running; the trans-
mission check display doesn't flash
when a button is pressed.
• The drive is running; the trans-
mission check display does not
run when a button is pressed.
• The drive isn't running; the
transmission check display flashes
when a button is pressed.
• The desired drive isn't
running.
Should you have any further queries, please contact your weinor specialist.
weinor Die Markise
Dieter Weiermann GmbH & Co.
Mathias-Brüggen Straße 110
50829 Köln
Hotline: +49 (0) 221/5 97 09-211
Fax: +49 (0) 221/59 43 62
www.weinor.com
Power Setting (for Lux and Tempura)
A power setting is an arbitrary brightness
or heating setting. After programming,
this can be activated by pressing the
button twice. Power settings can be
reprogrammed at any time.
How to programme the power setting
1. Set the level to maximum or minimum.
2. Hold down the
long as it takes to reach the desired
setting.
3. As soon as the desired setting is
reached, press the
4. The setting will stop and the power set-
ting is programmed.
Cleaning
• Only ever clean the device using a dry
cloth.
• Never use any detergents as these can
damage the plastic.
Declaration of Conformity
weinor hereby certifies that the weinor
Remoto 5M handheld remote control is in
compliance with the material require-
ments and all other relevant provisions of
the Guideline R&TTE 1999/5/EC.
Area of Application
This device has been certified for use in
Switzerland and within the European
Union.
Subject to change without notice
Cause
• The battery is low or
has been inserted
in the wrong way.
• The battery is low.
• The receiver is outside • Reduce the distance
the frequency range.
• No mains supply
(230 V).
• The circuit breaker
has been triggered.
• Wrong channel
selection.
or
or
button for as
button as well.
Remedy
• Insert a new battery
or the same battery
in the correct manner.
• Insert a new battery.
to the receiver.
• Connect the mains
(230 V).
• Switch on the circuit
breaker.
• Select the correct
channel.
Werbung
