Seite 4
Insert both of the part D clips into the two slots of part B and make sure both of the clips pass entirely through the slot with its tip coming back out to the front to form a firm joint. Schieben Sie die beiden Laschen der Teile D in die beiden dafür vorgesehenen Schlitze der Teile B.
Seite 5
Insert both of the part C clips into the two slots of part B and make sure both of the clips pass entirely through the slot with its tip coming back out to the front to form a firm joint. Schieben Sie die beiden Laschen der Teile C in die beiden dafür vorgesehenen Schlitze der Teile B.
Seite 6
Bend the clip of part F to 90 degrees and insert the clip to the slot at the middle of part C, then bend the tip part of the clips to 90 degrees for a tight joint. This is to ensure that part F doesn’t come off from part C. Biegen Sie die Laschen der Teile F um 90 Grad und schieben Sie sie in die dafür vorgesehenen Schlitze in der Mitte der Teile C.
Seite 12
CZ - Přemístěte stojan na požadované místo a poté jej připevněte ke stěně. Zabráníte případnému nebezpečí převrácení způsobené nerovným povrchem. Move the rack to the desired place after finishing the assembly, then fix it to the wall with the anti-tipping devices to prevent any potential tipping hazards caused by uneven ground or unevenly distributed items.
Einleitung Hinweise Bitte lesen Sie die folgende Anleitung Das Produkt ist zum Gebrauch in Innenräumen vorgesehen. Eine andere Verwendung aufmerksam durch und verwenden Sie das oder eine Veränderung/ein Umbau des Produktes ist nicht erlaubt und kann zu Produkt sachgemäß. Verletzungen und/oder Beschädigungen des Produktes führen. Montieren und verwenden Sie das Produkt nur wie in dieser Anleitung beschrieben.