Philips sonicare DiamondClean Smart 9000 HX9917/88 Bedienungsanleitung Seite 20

20
English
Cleaning
Toothbrush handle
Important: The wall adapter must be a safe extra low
voltage source, compatible with the electrical ratings
marked on the device.
Important: Only toothbrush handels HX993W,
HX993B, HX993P, HX993S, HX993L, HX993R,
HX992W, HX992B, HX992P, HX992S, HX992R can be
charged in the travel case. Other products and
batteries are not compatible with the travel case.
Note: It takes at least 24 hours to fully charge your
Philips Sonicare. You do not have to fully charge your
handle before first use, as the handle is pre-charged
for first use. However, it is recommended to fully
charge it after first use.
Note: This charger is designed to properly charge only
one handle at a time. This charger is not compatible
with other models of Philips Sonicare.
Note: Do not place metallic objects in the travel case,
as handle charging may be affected and may cause
the charger to overheat.
Note: Do not clean the brush head, handle or travel
case in the dishwasher.
Remove the brush head and rinse the metal shaft
1
area with warm water. Make sure you remove any
residual toothpaste.
Caution: Do not push on the rubber seal on the
metal shaft with sharp objects, as this may cause
damage.
2 Wipe the entire surface of the handle with a damp
cloth.
Note: Do not use isopropyl rubbing alcohol, vinegar
or bleach to clean handle as this may cause
discoloration.