Philips sonicare DiamondClean Smart 9000 HX9917/88 Bedienungsanleitung Seite 17

c. Brush head replacement reminder
d. BrushPacer
2
3 1
4 6
5
Activating or deactivating the pressure sensor
Place the handle, with a brush head attached, in
1
the plugged-in charger.
2 Pressure sensor is enabled by holding the
mode/intensity button and by pressing the power
button twice while on a charger. The handle will
beep twice to confirm it is enabled.
3 Pressure sensor is disabled by holding the
mode/intensity button and by pressing the power
button twice while on a charger. The handle will
beep once to confirm it is disabled.
Your Philips Sonicare is equipped with a smart feature
that tracks the wear of your brush head. Depending
on the pressure you apply and the amount of time
used, the brush head replacement reminder light
reminds you to change your brush head. It is
important to change your brush head in time in order
to guarantee the best cleaning & care of your teeth.
When the amber brush head replacement light starts
blinking, you should replace your brush head.
Activating or deactivating the brush head
replacement reminder
Place the handle in the plugged-in charger.
1
2 Brush head replacement reminder is enabled by
holding the mode/intensity button and by pressing
the power button three times while on the charger.
The handle will beep twice to confirm it is enabled.
3 Brush head replacement reminder is disabled by
holding the mode/intensity button and by pressing
the power button three times while on the charger.
The handle will beep once to confirm it is disabled.
The BrushPacer is an interval timer that has a short
beep and pause to remind you to brush the different
sections of your mouth. Depending on the brushing
mode you have selected (see 'Brushing modes'), the
BrushPacer beeps at different intervals during the
brushing cycle.
17
English