Worx WG894E Originalbetriebsanleitung Seite 9

Vibration emission value
Cutting wooden
a
h,WB
beams
Uncertainty K=1.5m/s²
The declared vibration total value and the
declared noise emission value have been
measured in accordance with a standard test
method and may be used for comparing one tool
with another.
The declared vibration total value and the
declared noise emission value may also be used
in a preliminary assessment of exposure.
WARNING! The vibration and noise
emissions during actual use of the power
tool can differ from the declared value depending
on the ways in which the tool is used especially
what kind of workpiece is processed dependant
on the following examples and other variations on
how the tool is used:
How the tool is used and the materials being cut
or drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if
any anti vibration and noise accessories are used.
And the tool is being used as intended by its
design and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation
of exposure level in the actual conditions
of use should also take account of all parts of
the operating cycle such as the times when the
tool is switched off and when it is running idle but
not actually doing the job. This may significantly
reduce the exposure level over the total working
period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in
anti vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
Cordless Li-Ion handy saw
=11.76m/s
2
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for sawing wood, plastic,
soft metal and building materials while resting
firmly on the workpiece.
ASSEMBLY
REPLACING/INSERTING THE SAW BLADE
Remove the battery pack from the socket
before carrying out any adjustment, servicing or
maintenance.
When mounting the saw blade, wear protective
gloves. Danger of injury when touching the saw
blade. When changing the saw blade, take care
that the saw blade holder is free of material
residue, e. g. wood or metal shavings.
1. SELECTING A SAW BLADE (See Fig. A)
NOTE: Only use maximum blade lengths
specified in table below for the intended purpose
of application. Failure to adhere to this advice
will result in damage to the product and void of
warranty.
Pruning blade (152mm,
6TPI, 65Mn)
Bi metal blade (152mm,
18TPI, HSS)
2. INSERTING A SAW BLADE (See Fig. B)
Remove the battery pack from the socket
before carrying out any adjustment, servicing or
maintenance.
Pull down the tool-free blade clamp lever (6),
Insert the blade shank into the blade holder until
it stops. Release the clamp lever (6) to lock the
blade (7/8) in position.
Check the tight seating of the saw blade. A loose
saw blade can fall out and lead to injuries.
3. REMOVING A SAW BLADE (See Fig. B)
To remove a blade, depress the clamp lever, pull
out the blade.
Typical application
Garden limbs, etc.
Metals and wood
,etc.
EN
9