Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 Installation
2
2.5.1 Horizontal position
Perform the following procedure for mounting TS002 over a ho-
rizontal surface.
1 If you want to fix it, screw the stand plate to the surface.
Otherwise go to step 2.
2 Set the TS002 on the stand plate and screw the stand plate
to the TS002.
3 Adjust the desired screen angle.
4 Set the cables and route them to the connection.
5 In case of fixing the power brick, screw the power brick su-
pports to the wall.
2.6 ELECTRICAL WIRING
TS002 must be connected to the power line using the power brick
adaptor and the corresponding cable.
DC POWER IN
11
PMML0232A-rev.0 - 07/2011
LAN
LAN
USB X4
2.5.2 Vertical position
Perform the following procedure for mounting TS002 over a ver-
tical surface.
1 Select the place where you want to fix the TS002. After that,
screw the stand plate to the surface. It's important to note that
stand plate must have its biggest site on the bottom, otherwise
it will not be enough strong to stand up the TS002.
2 Unscrew the screen support.
3 Rotate the monitor 180º.
4 Reinstall the 4 screws in order to fix the support to the monitor.
5 Set the TS002 on the stand plate and screw the plate on
theTS002.
6 Set the TS002 angle.
7 Set the cables and route them to the connection.
8 In case of fixing the power brick, screw the power brick su-
pports to the wall.
Ethernet cable must be connected in order to be able to read
CSNET WEB DATA.
AUDIO IN
AUDIO OUT
MIC
DB9 SERIAL X2
Remove those 4 screws
EXPANSION CARDS
European cable or US/Canadian
Werbung
