Peaq PMO S241-IFC Bedienungsanleitung Seite 13

General settings
MENU SETTINGS
With the device switched on, press the multifunction
switch to the left. The main menu opens. Press
the multifunction switch up or down to select the
desired submenu. To confirm your selection, press
the multifunction switch again to the left. You can
change the settings by pressing the multifunction
switch up or down. Confirm the setting by pressing
the multifunction switch again to the left.
By pressing the multifunction switch to the right,
you return to the corresponding upper menu.
To close the main menu, press the multifunction
switch to the right until it closes.
The following main menu options are available:
• Luminance
> Brightness
> Contrast
> Eco Mode
> DCR
> Overdrive
• Image Setup
> H. Position
> V. Position
> Clock
> Phase
> Image Ratio
• Color Setup
> Color Temp.
> Red
> Green
> Blue
• OSD Setup
> Language
> H. Position
> V. Position
> Timeout
> Transparence
• Reset
> Auto Config.
> Auto Color
> Reset
> Off Timer
IM_PMO-S241_S271-IFC_201127_V03_HR.indb 13 IM_PMO-S241_S271-IFC_201127_V03_HR.indb 13
• Extra
> Input Select
> Volume
> Freesync
Set menu language
The menu may be preset to English.
For easy use of the self-explanatory menu, it is
advantageous to set it to the respective native
language. Proceed as follows:
1. With the monitor turned on, press the multi-
selector switch to the left.
2. Select the OSD Setup item by pressing the
multi-selector up / down. Confirm the selection
by pressing the multifunction switch to the left.
3. The first point is Language. Press the
multifunction switch to the left to enter the
language selection menu.
4. Select the desired language by pressing the
multi-function switch up / down. Confirm the
selection by pressing the multifunction switch
to the left.
5. The desired language is now set. To exit the
menu, press the multifunction switch several
times to the right.
Reset settings to factory settings
1. With the monitor turned on, press the
multifunction switch to the left.
2. Select the Reset menu item by pressing the
multifunction switch up / down. Confirm the
selection by pressing the multifunction switch
to the left.
3. If necessary, select Reset by pressing the
multi-function switch up / down. Press the
multifunction switch to the left to confirm the
reset. All previously made individual settings
have now been reset and the menu is closed.
Change image format
1. While the monitor is on, press the multifunction
switch down until the desired format is selected.
You can choose between 4:3 and 16:9.
2. Confirm the selection
multifunction switch to the left or wait a few
seconds until the symbol disappears.
ENGLISH
by pressing the
13
27/11/2020 11:21 AM 27/11/2020 11:21 AM