AEG IKB64411XB Benutzerinformation Seite 60

Problem
Automatic Heat Up does not op‐
erate.
The heat setting changes be‐
tween two levels.
The control panel becomes hot to
the touch.
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
The outer ring is not activated.
and a number come on.
9.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
10. TECHNICAL DATA
10.1 Rating plate
Model IKB64411XB
Typ 61 B4A 00 AA
Induction 7.2 kW
60 ENGLISH
Possible cause
You use a very tall pot which blocks
the signal.
The highest heat setting is set.
The zone is hot.
Power management operates.
The cookware is too large or you put
it too close to the control panel.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
The diameter of the bottom of the
cookware is too small.
There is an error in the hob.
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 492 698 00
220 - 240 V / 400 V 2N, 50 - 60 Hz
Made in: Romania
Remedy
Use a smaller pot, change the cooking
zone or operate the hood manually.
The highest heat setting has the same
power as the function.
Let the zone become sufficiently cool.
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Use cookware with a bigger bottom di‐
ameter.
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
comes